| Issue |
E3S Web Conf.
Volume 130, 2019
The 1st International Conference on Automotive, Manufacturing, and Mechanical Engineering (IC-AMME 2018)
|
|
|---|---|---|
| Article Number | 01008 | |
| Number of page(s) | 10 | |
| DOI | https://doi.org/10.1051/e3sconf/201913001008 | |
| Published online | 15 November 2019 | |
Influences of Groove Angles and Filler Metals on 304L Stainless Steel to AISI 1040 Carbon Steel Dissimilar Joint by Gas Tungsten Arc Welding
Department of Mechanical Engineering, Faculty of Industrial Technology, Institut Teknologi Adhi Tama Surabaya,
60117
Surabaya
Indonesia
* Corresponding author: eriek@itats.ac.id
Dissimilar joint commonly applied on pressure vessel application in power plan field as joining between the tank and the stanchion of pressure vessel. This paper presents the investigations carried out to study the influence of groove angles and filler metals on 304L Stainless Steel to AISI 1040 Carbon Steel dissimilar joints. Gas Tungsten Arc Welding with 120 A of current was used on this research, joined the two different metals. The 30°, 45°, and 60° were used in this welding as parameters of V-groove angles. ER 308L-16 filler metal of stainless steel and ER 70S-6 filler metal of carbon steel were used as filler metals. Tensile test was conducted to obtain tensile strength of joint and to analysis of the effect of the welding parameters to the mechanical properties. The highest tensile strength was obtained from the 60° groove angle using ER 308L-16 filler metal of 614.54 MPa. In the other hand, 45° groove angle using ER 70S-6 filler metal obtained the lowest tensile strength of 578.66 MPa. The joining process of dissimilar welding using ER 308L-16 filler metal, filler metal for stainless steel, has obtained the highest tensile strength with wider groove angle as well.
Key words: Dissimilar welding / ER 308L-16 / ER 70S-6 / Welding process
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.