| Issue |
E3S Web Conf.
Volume 376, 2023
International Scientific and Practical Conference “Environmental Risks and Safety in Mechanical Engineering” (ERSME-2023)
|
|
|---|---|---|
| Article Number | 01010 | |
| Number of page(s) | 10 | |
| Section | I Environmental Risks and Safety in Mechanical Engineering | |
| DOI | https://doi.org/10.1051/e3sconf/202337601010 | |
| Published online | 31 March 2023 | |
Features of cutting processing of disperse-filled of aluminum-matrix composite materials
Bauman Moscow State Technical University, 2nd Baumanskaya street, 105005, Moscow, Russia
* Corresponding author: kurganova_ya@mail.ru
The results of studies of machinability by cutting of experimental samples of promising aluminum-matrix disperse-filled composition materials are presented. The axial force and cutting torque during drilling were measured, the surface roughness of the obtained holes was studied, and the shape of the chips was analyzed. Analysis of the obtained data allowed to determine the composition of aluminum-matrix material, which provides lower cutting forces, roughness of the machined surface and better chip formation. The influence of the filler composition on the machinability by cutting of aluminum-matrix composites is shown.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.