Laboratory investigation of the effects of grain size on the dynamics of debris flows: Measurement of pore fluid pressure in an open channel

¹ School of Agriculture, Utsunomiya University, Utsunomiya, Japan
² Graduate School of Agricultural and Life Sciences, The University of Tokyo, Tokyo, Japan

^* Corresponding author: sakai@cc.utsunomiya-u.ac.jp

Abstract

The dynamics of debris flow depend on internal stress components, such as particle–particle stress, the stress exerted by pore water, and interactions between particles and pore water. Although dominant internal stress components depend on the grain size composition, the effects of grain size on the dynamics of debris flow are not fully understood. To investigate the effects of grain size on the dynamics of debris flows, pore fluid pressures were measured in an open channel experiment. In the experiment, monodisperse debris flows were triggered for five different grain sizes: 0.2, 0.8, 1.3, 2.2, and 2.9 mm. The pore fluid pressures in debris flows of 0.2 mm grains had larger excess pressures over the hydrostatic pressure, and were close to the total normal stress, while those of other grain sizes had smaller excess pressures and were relatively close to the hydrostatic pressure. Comparing the measured friction factors and theoretical ones for stony debris flows, particle–particle stress dominated in debris flows, except for 0.2 mm grains, and the measured excess pore pressures could be explained by the Reynolds stress of pore fluid due to shear by particles in laminar motion. By contrast, particle–particle stress did not dominate in debris flows of grain size 0.2 mm, and a large portion of the particles was in suspension affected by turbulence. These differences in flow dynamics may correspond to the flow transition from laminar to turbulent flow described by the threshold of relative flow depth, which is the ratio of the flow depth to grain size.