Issue |
E3S Web Conf.
Volume 67, 2018
The 3rd International Tropical Renewable Energy Conference “Sustainable Development of Tropical Renewable Energy” (i-TREC 2018)
|
|
---|---|---|
Article Number | 01022 | |
Number of page(s) | 5 | |
Section | Smart Grid and Regulation | |
DOI | https://doi.org/10.1051/e3sconf/20186701022 | |
Published online | 26 November 2018 |
Fabrication of low cost perovskite solar cell under ambient conditions using only spin coating deposition method
Department of Electrical Engineering, Faculty of Engineering, Universitas Indonesia, Depok 16424, Indonesia
* Coresponding author: pupu@eng.ui.ac.id
Indonesia is an archipelagic nation that has many small islands where the average load is low and currently supplied by diesel power generators. The drawbacks from these generators are cost constraints from its operation. Solar cells are the solution of this problem with the support of daily average radiation in Indonesia of 4.8 kWh/m2/day. There has been a lot of technology for the construction of solar cells such as silicon based, copper indium gallium selenide (CIGS), which was already successfully commercialized. However, these technologies have been obsolete and started to reach its maximum potential. Perovskite solar cells have a very high future potential, due to the increase on the efficiency of this technology in a relatively short amount of time. The current challenge for the fabrication of perovskite solar cell is the material cost and fabrication cost. This paper discussed the low-cost fabrication of perovskite solar cell using only spin coating deposition method and relatively also low-cost materials for the structure of the perovskite solar cell itself. As a result, we achieve perovskite solar cell with VOC of 0.6 V, ISC of 13 mA, FF of 0.28, and 1.2% efficiency.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.