Issue |
E3S Web Conf.
Volume 68, 2018
The 1st Sriwijaya International Conference on Environmental Issues 2018 (1st SRICOENV 2018)
|
|
---|---|---|
Article Number | 04004 | |
Number of page(s) | 7 | |
Section | Mitigation and Adaptation in Climate Change in Wetland | |
DOI | https://doi.org/10.1051/e3sconf/20186804004 | |
Published online | 27 November 2018 |
Damage Analysis of Moldboard Plow
Department of Mechanical Engineering, Universitas Sriwijaya, 30662, Indralaya, South Sumatera, Indonesia
Moldboard plow is a tool used to cultivate the agricultural land. The material of the moldboard is a double layer where the outer layer is high carbon steel and the inside is a low carbon steel. The findings on the side edge of the moldboard plow are often damaged due to bent deformation and then broken. The study was conducted to determine the cause of the damage through simulation and testing laboratory. The simulation results show that the moldboard is overloaded by its material capability. This is shown also from the results of testing the chemical composition that this material is a low-alloy steel single layer without surface hardening. Hardness tests conducted using Rockwell C show that this steel has a tensile strength of only about 400 MPa. This is reinforced by the results of microstructural observations showing that more than 99% of the phases are ferrite.
© The Authors, published by EDP Sciences, 2018
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.