E3S Web Conf.
Volume 94, 2019International Symposium on Global Navigation Satellite System 2018 (ISGNSS 2018)
|Number of page(s)||7|
|Section||GNSS Today and Future|
|Published online||08 May 2019|
The Potency of the Modernized GNSS Signals for Real-Time Kinematic Positioning
Geodesy Research Group, Faculty of Earth Sciences and Technology, Institute of Technology, Bandung, Indonesia
2 Coastal, Ocean and Maritime Engineering Research Group, Faculty of Earth Sciences and Technology, Institute of Technology, Bandung, Indonesia
* Corresponding author: firstname.lastname@example.org
GNSS positioning has become popular in the past decade as an efficient method of precise and real-time positioning. It is relatively low cost and ease-of-use. Up to now, several parameters were defined to characterize the performance of real-time positioning: availability, precision, accuracy. This article evaluates the performance of signal linear combinations for real-time positioning, both for static as well as the kinematic positioning. This article starts with the investigation of linear combinations (LC) rising from the carrier frequencies of the GNSS systems. Some Linear Combination shows potential benefits in carrier phase integer ambiguity resolution, particularly utilizing the Galileo and Beidou signal phase carrier. For each system, a set of combinations was studied, analyzed, and then selected during the development of GNSS positioning method utilizing the Least-squares Ambiguity Decorrelation Adjustment (LAMBDA). Special signal selection can affect the estimated position and its standard deviation. To further analyze, the results obtained from data processing are compared with respect to baselines and signals. The ambiguity fixing rate is correlated with the baseline length and the method as well as the signals that were used. The analysis of the measurement noise level was first conducted to set a baseline for the real-time GNSS positioning application. According to the results and to assess the data quality and positioning performance of GNSS in respect with GPS (Global Positioning System), an experimental test has established using MGEX data. This research investigates the satellite visibilities, multipath, Signal to Noise Ratio (SNR), and positioning performance. It is shown that in every epoch, at least 8 satellites are visible. The SNR’s are up to 60 dBHz, the code multipath residuals varies within ~1 m, while the phase residuals varies by about ~2 cm. hence the modernized GNSS signals have potencies to improves the RTK positioning.
© The Authors, published by EDP Sciences, 2019
This is an open access article distributed under the terms of the Creative Commons Attribution License 4.0 (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.