Issue |
E3S Web Conf.
Volume 135, 2019
Innovative Technologies in Environmental Science and Education (ITESE-2019)
|
|
---|---|---|
Article Number | 03035 | |
Number of page(s) | 14 | |
Section | Green Architecture and Sustainable Urban Design | |
DOI | https://doi.org/10.1051/e3sconf/201913503035 | |
Published online | 04 December 2019 |
PMB quality problems based on its morphology and used equipment
1
Belgorod State Technological University VG Shukhov, Kostukova str., 46, Belgorod, 308012, Russia
2
Moscow State University of Civil Engineering, Yaroslavl h., 26, Moscow, 129337, Russia
* Corresponding author: roruri@rambler.ru
In the first part of the study, a direct relationship is established between the influence of the morphology of PMB (polymer modified binder) on the totality of its consumer properties and its tendency to destruction. The second part of the study is devoted to the influence of technological equipment used for the production of polymer modified binder on its properties. It was experimentally established that having the same initial components, PMB of completely different quality were obtained at the output. According to the degree of increase in rigidity (penetration value at 25 °C), obtained PMBs can be conditionally positioned as follows: prepared using a paddle mixer, a colloid mill, and an extruder. It is proved that the high elastic properties of PMB can be achieved by using paddle mixers that do not damage the long polymer macromolecules during the process. However, such binders are prone to delamination. To eliminate this negative aspect, the use of additional crosslinking agents is necessary. PMB prepared using an extruder has lost its elastic abilities, has become tough, with a high rate of cohesive strength. Thus, it is noted that when designing PMB compositions, it is necessary to carefully choose not only the raw material base but also the technological equipment for its preparation.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.