Issue |
E3S Web Conf.
Volume 137, 2019
XIV Research & Development in Power Engineering (RDPE 2019)
|
|
---|---|---|
Article Number | 01028 | |
Number of page(s) | 5 | |
DOI | https://doi.org/10.1051/e3sconf/201913701028 | |
Published online | 16 December 2019 |
Balancing axial force in centrifugal pumps with pump out vanes
Institute of Heat Engineering, Warsaw University of Technology. 25 Nowowiejska Street, Warsaw 00-665, Poland
Application of pump out vanes is one of the solutions to reduce hydraulic axial force generated during centrifugal pump operation. This article presents the cause of the occurrence of hydraulic axial force and method of calculating pressure distribution at the rear of the impeller used to design pump out vanes properly. It illustrates results of pump out vanes CFD calculations and its validation by measurements. The article reviews the methods of reducing pressure on the rear wall of the centrifugal pump's rotor using pump out vanes. It presents empirical formulae allowing calculation of pressure depending on the geometrical parameters of the blades. The article presents various design solutions of pump out vanes.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.