E3S Web Conf.
Volume 164, 2020Topical Problems of Green Architecture, Civil and Environmental Engineering 2019 (TPACEE 2019)
|Number of page(s)||5|
|Published online||05 May 2020|
Geometric characteristics of micro holes in a fabric air duct
Moscow State University of Civil Engineering, Yaroslavskoye shosse, 26, Moscow, 129337, Russia
* Corresponding author: email@example.com
The purpose of this study is to develop new effective air supply devices, taking into account the current level of development of science and technology and the emergence of modern high-tech materials. These include microperforated fabric ducts made of a polymer composite material. The holes in such ducts are cut with a laser. The results of studying the geometric characteristics of micro holes in a textile air duct section using an optical microscope are presented. It was found that the area of the holes varies in the range from 39629 μm2 to 50955 μm2. The average value of the area of micro holes is S = 47718 µm2, which corresponds to a diameter of d = 242 µm (0.24 mm), and the diameter declared by the manufacturer is 0.2 mm. The results obtained make it possible to determine the resistance of a microperforated fabric air duct.
© The Authors, published by EDP Sciences 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.