E3S Web Conf.
Volume 174, 2020Vth International Innovative Mining Symposium
|Number of page(s)||6|
|Section||Innovations in Mining Machinery|
|Published online||18 June 2020|
Determination of contact temperature on cutting disc during rock destruction
T.F. Gorbachev Kuzbass State Technical University, Kemerovo, Russia
During the destruction of rocks by disc cutters the question of their operation without water cooling is arising. To implement this an approach to determining the temperature of the disk cutter is considered in the article. The calculations of heating of the disc cutter with various geometric parameters (diameter, sharpening angles, blunting edge radius) and geological conditions under different cutting conditions (cutting depth) are presented. The disc cutter temperature and comparison with a critical one is given. The results allow to increase wear resistance and thereby determine the modes of operation in which forced cooling of the cutting disc is not required.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.