| Issue |
E3S Web Conf.
Volume 213, 2020
2nd International Conference on Applied Chemistry and Industrial Catalysis (ACIC 2020)
|
|
|---|---|---|
| Article Number | 03011 | |
| Number of page(s) | 4 | |
| Section | Environmental Chemical Research and Energy-saving Technology Application | |
| DOI | https://doi.org/10.1051/e3sconf/202021303011 | |
| Published online | 01 December 2020 | |
The influence of different cutting parameters on the glass edge quality
Beijing Institute of Aeronautical Materials, Beijing 100095, China
a lixiaoyu621@126.com
b liangbaojiang@hotmail.com
f Yue.Yan@biam.ac.cn
The influence of different cutting parameters on the glass edge quality was investigated, including the cutter material, the sharpening angle of the cutting roll, the cutting speed and the load applied to the roll. The results show that there are less defects on the edge of the glass cut by diamond cutter. There is no obvious influence of cutting speed on the glass edge quality. The cutter with a smaller sharpening angle is more applicable for the cutting of thin glass, and the thick glass is more suitable to use a bigger sharpening angle cutter. Higher cutting load is helpful for the breaking of the glass along the cutting line. However, it may cause more defects on the edge and the surface of the glass.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.