| Issue |
E3S Web Conf.
Volume 281, 2021
IV International Scientific Conference “Construction and Architecture: Theory and Practice of Innovative Development” (CATPID-2021 Part 1)
|
|
|---|---|---|
| Article Number | 03010 | |
| Number of page(s) | 5 | |
| Section | Building Materials and Technologies of Binders, Concrete and Building Ceramics | |
| DOI | https://doi.org/10.1051/e3sconf/202128103010 | |
| Published online | 02 July 2021 | |
Composition of molding material for ceramic tiles
1 Don State Technical University, 344002, Rostov-on-Don, Russia
2 Rostov-on-Don College of Communication and Informatics, 344000, Rostov-on-Don, Russia
* Corresponding author: Luiza.seferyan@mail.ru
This article discusses the problems of creating new compositions for ceramic tiles. There are two ways to process the composition of the molding material - dry and wet. A description of the wet processing method is given. The molding of the plastic mass is carried out by pressing to obtain a tile with a size of 50 x 150 mm. The molded product goes through the following stages of the technological regime: blowing in a drying stove with an increase in temperature from 25 °C to 700 °C for 3-4 hours. Further, at a speed of 15-20 degrees per minute, the temperature rises to 1050 0C and then the heat treatment continues for 30 minutes. After annealing, the product is cooled and tested.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.