Issue |
E3S Web Conf.
Volume 299, 2021
4th Annual International Conference on Energy Development and Environmental Protection (EDEP 2021)
|
|
---|---|---|
Article Number | 03015 | |
Number of page(s) | 6 | |
Section | Development and Utilization of Resources | |
DOI | https://doi.org/10.1051/e3sconf/202129903015 | |
Published online | 05 August 2021 |
Design and Optimization of Rubber Tube of Orifice BoP
Xi’an Research Institute, China Coal Technology & Engineering Group Corp, Xi’an 710077, China
* Corresponding author: liuzhi030191@sina.com
The rubber tube is made of rubber material. It is the important part of the orifice boP. The rubber tube is squeezed and deformed to contact with the drill pipe to achieve the sealing function. There are large deformation and contact problems in the sealing process of rubber, which is difficult to calculate theoretically. In this paper, finite element analysis software is used to analyze the contact stress between the designed rubber cylinder and the drill pipe under different loads and the influence of friction factor on the contact stress. The influence rules are summarized, the structure of the rubber cylinder is optimized, and the contact stress of the optimized rubber cylinder is analyzed. The results meet the design requirements.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.