| Issue |
E3S Web Conf.
Volume 352, 2022
7th International Conference on Energy Science and Applied Technology (ESAT 2022)
|
|
|---|---|---|
| Article Number | 01085 | |
| Number of page(s) | 5 | |
| Section | Fossil Energy & Geological Engineering | |
| DOI | https://doi.org/10.1051/e3sconf/202235201085 | |
| Published online | 27 June 2022 | |
A method for predicting the build-up rate of single-bending positive displacement motor assembly in compound drilling
1 Sinopec Northwest Oil Field Company, Xinjiang Urumqi 830011, China
2 Sinopec Key Laboratory of EOR for Fractured-Cave Reservoirs, Urumqi, Xinjiang 830011, China
3 Downhole Operation Company of Chuanqing Drilling Engineering Co., Ltd., Chengdu 6100523, Sichuan, China
4 China University of Petroleum (Beijing), Beijing 100249, China
* Corresponding author: diaobinbin@126.com
Accurately predicting the build-up rate of single-bending positive displacement motor (PDM) assembly in compound drilling is helpful to rational design the well trajectory, realize compound drilling in long well sections and improve the rate of penetration. Based on the calculation model of corrected build-up rate of single-bending PDM assembly in sliding drilling, the build-up rate calculation method of single-bending PDM assembly in compound drilling was established by combining the trajectory measurement data of the drilled sections, and the influence law of parameters such as bending angle, weight on bit, bit anisotropy index and formation inclination on the build-up rate of compound drilling was analyzed. And the following results are obtained. First, the build-up effect of the single-bending PDM assembly during compound drilling is mainly the result of the leverage effect and pendulum effect of the drill tool assembly, as well as the natural deviation of formation. Second, the composite drilling build-up rate is related to the drilling tool structure, bit performance, drilling parameters, formation inclination and other factors. In conclusion, the factors affecting the build-up rate of conventional drilling tool assembly also have impacts on the composite drilling build-up rate of single-bending PDM assembly. The method is important for the control of well trajectory during compound drilling.
© The Authors, published by EDP Sciences, 2022
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.