| Issue |
E3S Web Conf.
Volume 385, 2023
2023 8th International Symposium on Energy Science and Chemical Engineering (ISESCE 2023)
|
|
|---|---|---|
| Article Number | 02012 | |
| Number of page(s) | 5 | |
| Section | Green Chemical Technology and Energy Saving and Emission Reduction | |
| DOI | https://doi.org/10.1051/e3sconf/202338502012 | |
| Published online | 04 May 2023 | |
Flash butt welding on microstructures and mechanical properties of joints for high strength acid resistant steel
The State Key Laboratory of Rolling and Automation, Northeastern University, Shenyang 110819, China
* E-mail: gaoxiuhua@126.com
In this research, the 600 MPa acid resistant steel was used as flash butt welding base material, to study the effect of different upset allowance on the microstructure and mechanical properties of the joints. The results can be obtained as follows: with the increase of the upset allowance, it has a significant effect on the elongation, the ferrite content in the heat affected zone increases, and the joint strength first increases and then slowly decreases. When the upset allowance is bigger than 4mm, there are wide and large bainitic ferrites in the coarse grained zone, the joint strength deteriorates sharply. When the upset allowance is 3-4mm, the mechanical properties of the welded sample are the best, the tensile strength is 686-708MPa, the yield strength is 610-636MPa, the elongation is higher than 13.77%. The steel matrix can be strengthened effectively by forming grain refinement and dispersed granular bainite with proper upset allowance. The different hardness distributions of welded joints to display the difference of microstructure in different regions.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.