Prospects for using amorphous ferromagnetic alloy microwire for reinforcement of cement mortar

Moscow State University of Civil Engineering, 26, Yaroslavskoye shosse, Moscow, 129337, Russia

^* Corresponding author: InozemcevAS@mgsu.ru

Abstract

Traditionally, fibers for fiber-reinforced concrete are made of metal, polypropylene, basalt or glass. На сегодняшний день для строительства актуально использование волокон с уникальными электрофизическими свойствами. The possibilities of using a microwire made of an amorphous ferromagnetic alloy based on cobalt with a shell of borosilicate glass in concrete technologies are studied in this paper. The influence of the content of fibers of different sizes (length 7 and 15 mm) on the rheological and physico-mechanical properties of the solution was established. The deterioration of the workability of mixtures and the average density of the composite with the introduction of the studied fiber is shown. It has been established that the spread diameter of the mortar mixture with a fiber content of 0.5...3.0 % by weight of Portland cement is reduced by 9.8...26.1% compared to the control composition. It is shown that the short fiber (7 mm) at the maximum content (3 %) leads to a more significant decrease in the average density (up to 9.6 %) compared to the long fiber (15 mm) of the same concentration (reduction is no more than 4 %). A positive effect on the flexural strength and crack resistance of the solution was established. The increment of flexural and compressive strength ranges from 1.11 to 1.54 and from 0.99 to 0.78 respectively with increasing fiber concentration. The presence of fiber in the composition of the solution allows you to increase the crack resistance from 0.098 to 0.164. The increase in the crack resistance coefficient for compositions with a fiber 7 mm long is 51...68 % and compositions with a fiber 15 mm long is 22...37 %. The possibility of using such microwire based on a ferromagnetic alloy for dispersed reinforcement of cement solutions opens up prospects for the creation of “smart” materials.