Issue |
E3S Web Conf.
Volume 459, 2023
XXXIX Siberian Thermophysical Seminar (STS-39)
|
|
---|---|---|
Article Number | 02003 | |
Number of page(s) | 4 | |
Section | Convective Flows and Heat Transfer in Single-Phase Media | |
DOI | https://doi.org/10.1051/e3sconf/202345902003 | |
Published online | 04 December 2023 |
Effect of wall electrical conductivity and transverse magnetic field on turbulent mercury flows in nonuniformly heated pipes
National Research University “Moscow Power Engineering Institute” (MPEI), Moscow, Russian Federation
The problem of mixed convection of mercury in a horizontal circular tube heated from below under the effect of a transverse magnetic field is examined. A numerical study was performed using the LES method in a conjugate formulation including the wall which may be with or without a fouling layer (deposits) with low electrical conductivity on its inner surface. To simulate the subgrid viscosity, the CSM model was used. In the case with a Reynolds numbers of Re0 = 5000, Hartmann number of Ha0 = 150, Grashof number of Gr0 = 2.75×106, which is based on the inner radius of the pipe, and Prandtl number of Pr = 0.024, a strong influence of the fouling layer electrical conductivity on the fluid flow structure and the amplitude and frequency of fluctuations of temperature, velocity, and electric potential has been found.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.