| Issue |
E3S Web Conf.
Volume 459, 2023
XXXIX Siberian Thermophysical Seminar (STS-39)
|
|
|---|---|---|
| Article Number | 05002 | |
| Number of page(s) | 5 | |
| Section | Heat and Mass Transfer During Phase Transitions | |
| DOI | https://doi.org/10.1051/e3sconf/202345905002 | |
| Published online | 04 December 2023 | |
Experimental determination of the cooling efficiency of a high-temperature surface by a pneumatic nozzle
MPEI, General Physics and Nuclear Fusion department, 111250 Moscow, Russia
* Corresponding author: demidovas@mpei.ru
The cooling of surfaces that perceive high heat fluxes (more than 7 MW/m2) at the current pace of development of the energy sector will become one of the main problems of the near future. In this paper, as one of the options for effective cooling of high-temperature surfaces of various geometries, the results of an experimental study of the cooling process by a spray flow directed perpendicular to the cooled surface are presented. Two different types of nozzles are used for cooling. Water consumption varied in the range (8.3÷25.0)∙10−3kg/s, air consumption in the range (0.3÷1.1)∙10−3kg/s. The maximum value of the density of the removed heat flux for one of the nozzles is 11.3 MW/m2 at a water flow rate 25.0∙10−3kg/s, the average value of the heat transfer coefficient during spray cooling was about 100 kW/m2K.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.