Issue |
E3S Web of Conf.
Volume 550, 2024
The 16th International Scientific Conference of Civil and Environmental Engineering for the PhD. Students and Young Scientists – Young Scientist 2024 (YS24)
|
|
---|---|---|
Article Number | 01032 | |
Number of page(s) | 7 | |
Section | Civil Engineering | |
DOI | https://doi.org/10.1051/e3sconf/202455001032 | |
Published online | 16 July 2024 |
Increase the internal surface temperature to eliminate surface condensation on the window
Faculty of Civil Engineering BUT, Veveří 331/95, Brno, 60200, Czech Republic
* Corresponding author: 167550@vutbr.cz
One of the most critical places in buildings in terms of physical thermal properties are windows. This is the most frequent place where the temperature drops below the dew point and surface condensation, or mould, develops. The work deals with the study of the surface temperature courses at the critical points of window glazing and connection joints and the subsequent improvement of the initial unsatisfactory condition by using a patented technology, a conductive material without further intervention in the structure. In the case of a very unsatisfactory condition, a heating resistance wire was attached to the bar, which in combination with the bar distributes the heat to a wider area. The evaluation of the surface temperature increase was performed in a steady-state thermal analysis with fixed boundary conditions and then with the influence of the flow in a room with the heater placed under the window.
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.