| Issue |
E3S Web Conf.
Volume 695, 2026
2nd International Conference on Sustainable Chemistry (ICSChem 2025)
|
|
|---|---|---|
| Article Number | 03002 | |
| Number of page(s) | 9 | |
| Section | Green Chemistry | |
| DOI | https://doi.org/10.1051/e3sconf/202669503002 | |
| Published online | 24 February 2026 | |
Evaluation of draw solution for enhanced microalgae harvesting via forward osmosis
1 Centre for Water Research, Faculty of Engineering, Built Environment and Information Technology, SEGi University, 47810 Kota Damansara, Selangor Darul Ehsan, Malaysia
2 Faculty of Engineering, Universitas Negeri Malang (UM), Jalan Semarang No. 5, Malang 65145, East Java, Indonesia
* Corresponding author: This email address is being protected from spambots. You need JavaScript enabled to view it.
Abstract
Microalgae have attracted increasing attention as a renewable resource with potential applications in biofuels, wastewater treatment, and environmental remediation. However, large-scale harvesting remains a critical challenge due to the high energy requirements and cost inefficiencies of conventional techniques such as centrifugation and chemical flocculation. This study investigates forward osmosis (FO) as a sustainable alternative for microalgae harvesting, with sodium chloride (NaCl) evaluated as the draw solution (DS). A cellulose triacetate (CTA) FO membrane was employed to concentrate Chlorella vulgaris cultures using draw solution concentrations ranging from 2M to 7M. System performance was assessed based on water flux, electrical conductivity (EC), and total solids (TS) recovery under varying operating conditions. Results showed that water flux depended strongly on DS concentration, with higher NaCl molarity enhancing osmotic pressure and initial flux. The 6M NaCl DS produced the highest water flux (12.7 L/m2·h), although performance declined over time due to dilution effects and membrane fouling. The 4M NaCl solution provided the best balance between efficiency and cost, yielding the highest TS recovery (18.4%). FO effectively concentrated biomass, with the final concentration dependent on initial culture density and operational settings. FESEM analysis confirmed the presence of fouling layers on the membrane surface, which were manageable with periodic cleaning. Overall, the results highlight the importance of draw-solution optimisation to balance concentration efficiency, operational stability, and salt diffusion in FO-based microalgae harvesting systems.
© The Authors, published by EDP Sciences, 2026
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.

