Study of a gas turbine unit energy efficiency

Volgograd Technical University, Institute of Architecture and Construction, 400074, Volgograd, Russia

^* Corresponding author: n.y.ermilova@yandex.ru

Abstract

The method of the gas turbine unit and the waste heat boiler gas-air duct circuit modernization is considered. The operation scheme of a gas turbine unit and a waste heat boiler with the use of a catalytic afterburner has been shown. There is also a decrease in nitrogen and carbon oxides in the exhaust steam-and-gas mixture due to a deeper cleaning process of the exhaust steam and gas mixture, which leads to an increase in the service life of the waste heat boiler [1]. A more complete process of heat transfer to the coolant in the furnace section of the boiler is performed due to the cleaner steam and gas mixture in the waste heat boiler and due to a decrease in the boiler tubes growth formation by the combustion products. This makes it possible to reduce the cost of fuel consumption by gas burners of the waste heat boiler. Also, as a result of this process, it is possible to reduce fuel consumption for the needs of heating the feed water and the auxiliary needs of a power unit. This article proposes to use lattice devices in the afterburner, treated with active substances by the ion implantation method, as one of the most promising ways of modifying lattice surfaces [2 – 6]. These processes occurring when the steam-and-gas mixture passes through the afterburner, allow increasing the cycle efficiency factor and limit of maximum allowable concentrations (MAC) emissions for various options for the exhaust steam-and-gas mixture utilization of a gas turbine unit (GTU) and heat supply to the waste heat boiler.