E3S Web Conf.
Volume 104, 2019International Conference “Energy Efficiency and Energy Saving in Technical Systems” (EEESTS-2019)
|Number of page(s)||5|
|Section||Modern Energy Efficient Automation Technology|
|Published online||21 June 2019|
The effect of thermal treatment on the properties of SLM samples with a bionic design
I.M. Sechenov First Moscow State Medical University, 119146 Moscow, Russia
2 АО «Nauka i innovacii», 115035 Moscow, Russia
3 Ural Federal University named after the first president of Russia B.N. Yeltsin, 620002 Ekaterinburg, Russia
* Corresponding author: firstname.lastname@example.org
This article shows the possibility of additive technology applied to medical implants. It’s shown the difference of physical properties such as elastic module of bones, implants made of traditional technology and implants made of additive technology. Porous structure has been chosen for future implants through designing its and further calculation of its mechanical properties using software such as Solid Works, Logos and Ansys. To confirm the right choice of design of structure we manufactured samples with using Rosatom 3D printer, made heat treatment and tested them.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License (http://creativecommons.org/licenses/by/4.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.