E3S Web Conf.
Volume 208, 2020First Conference on Sustainable Development: Industrial Future of Territories (IFT 2020)
|Number of page(s)||7|
|Section||Energy for Sustainable Development|
|Published online||24 November 2020|
Equations of temperature graphics of a heating point with a two-stage scheme of heat exchangers of hot water supply
Novosibirsk State University of Architecture and Civil Engineering (Sibstrin), Leningradskaya, 113, 630008 Novosibirsk, Russia
* Corresponding author: firstname.lastname@example.org
The temperature of the water returned to the heating network from consumers largely determines the energy efficiency of the heat supply system. It depends on a number of parameters: outside air temperature, hot water supply heaters connection scheme, daily water consumption in the hot water supply system. The calculation of this temperature is usually performed numerically, which makes it difficult to control the modes of the heat supply system. From a practical point of view, a simpler toolkit is needed. In this paper, equations are proposed that allow directly determining the change in the heat output of heat exchangers depending on the outside air temperature and the temperature of the network water returned to the heating network. These equations are obtained on the basis of systematic modeling of variable operating modes of the heat supply system, using the method previously proposed by the author. The operating characteristics of the heat station are taken into account by the coefficients of the equations, for the determination of which the calculation formulas were obtained. The equations used are valid for substations with a two-stage mixed scheme of hot water supply heaters in the mode of maximum water consumption.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.