E3S Web Conf.
Volume 227, 2021Annual International Scientific Conference on Geoinformatics – GI 2021: “Supporting sustainable development by GIST”
|Number of page(s)||6|
|Section||GIS in Mechanization and Automatization of Agriculture and Water Resources|
|Published online||06 January 2021|
Indicators of the combine equipped with GPS receiver in sunflower harvesting
SRIMA, 110800 Tashkent region, Yangiyul district, Samarkand 41, Uzbekistan
2 TerSU, Transport Systems and Facilities Department, 190111 Termez, Barkamol avlod 43 Uzbekistan
3 Termez branch TSTU, Electrotechnical Department, 190111 Termez, Barkamol avlod 26 Uzbekistan
4 TIIAME, Agricultural Machines Department, 100000 Tashkent, Kari Niyaziy 39 Uzbekistan
* Corresponding author: email@example.com
In sunflower harvesting for decreasing the grain loss and increasing using efficiency of the combines GIS technologies, namely combines equipped with GPS devices and control sensors provides good results. This is explained that by the fact that with a length of 400-500 mm, the cut baskets did not partially fall on the divider-guide, and with a length of 700-800 mm, seed losses increased due to uncut baskets, since with an increase in length the divider-guide bent some stems forward and did not cut them. Analyzing the studies of working process of the adapted grain harvester combine Dominator-130 that equipped with GPS receiver and grain level indicator sensor in sunflower harvesting defined optimal parameters its header, as the following values: the length of the divider-guide (lТ) - 0.6 m, the gap between the divider-guides (ST) - 0.1 m, the installation angle of the divider-guide relative to the bottom of the header (βТ) - 5 degrees. With these parameters, the combine that has adapted header for harvesting sunflower meets the agro technical requirements for harvesting sunflower.
Key words: sunflower harvesting / combine / GIS / GPS receiver / grain sensor / header / adaption / guide-divider
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.