| Issue |
E3S Web Conf.
Volume 264, 2021
International Scientific Conference “Construction Mechanics, Hydraulics and Water Resources Engineering” (CONMECHYDRO - 2021)
|
|
|---|---|---|
| Article Number | 04046 | |
| Number of page(s) | 8 | |
| Section | Mechanization, Electrification of Agriculture and Renewable Energy Sources | |
| DOI | https://doi.org/10.1051/e3sconf/202126404046 | |
| Published online | 02 June 2021 | |
Technology and machine parameters for preparing the soil for sowing cotton
1 Karshi Engineering Economic Institute, Karshi, Uzbekistan
2 Karshi branch of Tashkent Institute of Irrigation and Agricultural Mechanization Engineers
3 Karshi State University, Karshi, Uzbekistan
* Corresponding author: sanjar_toshtemirov@mail.ru
The study aims to justify the design scheme and main parameters of the combined aggregate for soil preparation for cotton sowing on ridges. The authors have developed the technology of soil preparation for cotton sowing on ridges and the aggregate for its implementation. The technology and design scheme of the developed aggregate are presented. The unit consists of a mouldboard deep loosener with a sloping rack and a ridge maker. The basic principles and methods of classical mechanics, mathematical analysis, and statistics were used in this study. The optimum constructive scheme of combined aggregate is grounded. It was established that to provide formation of new ridges instead of existing ones on fields without stems of cotton with the required degree with minimum power consumption working surfaces of inclined deep looseners equipped with mouldboards and rippers should be turned to each other and shifted relative to each other in a longitudinal plane. The formation of ridges to the required degree with minimal energy input is ensured at a width and length of the subsoiler's chisel, respectively 5 and 20 cm, the width of the wing width 21 cm, wing length between 47 and 49 cm, minimum longitudinal spacing between subsoilers 35 cm.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.