Mathematical modeling of the technological process of operation and parameters of the device for formation of longitudinal rollers (pawls) between cotton rows

Bukhara branch of the Tashkent institute of irrigation and agricultural mechanization engineers, Bukhara, Uzbekistan

^* Corresponding author: holimov@mail.ru

Abstract

This article reveals the features of mathematical modeling of the technological process of work and the parameters of the device for the formation of longitudinal pawls between cotton rows. And also, the results of the STUDY are presented, and the following main conclusions were made: the task of mechanizing the formation of longitudinal legs can be solved by lifting the soil from the two side furrows and throwing it into the central furrow using a palletizing device with active working organs. Studies have shown that for the qualitative formation of longitudinal dogs between rows of cotton, it is advisable to use a device with a single-pass continuous auger. To avoid damage to cotton seedlings, to ensure the required productivity with minimal energy consumption, the screw device must have the following parameters: the screw diameter is 400 mm, the inner and outer diameters of the screw pipe 420 and 426 mm; respectively, the pitch of the screw is 320 mm; the rotation speed of not less than 325 rpm; and the mounting angle relative to horizontal-not more than 35 °; the entry angle into the ground shield located in front of the screw tube, the device needs to be within 24-25º.