Issue |
E3S Web Conf.
Volume 267, 2021
7th International Conference on Energy Science and Chemical Engineering (ICESCE 2021)
|
|
---|---|---|
Article Number | 01018 | |
Number of page(s) | 8 | |
Section | Energy Development and Utilization and Energy-Saving Technology Application | |
DOI | https://doi.org/10.1051/e3sconf/202126701018 | |
Published online | 04 June 2021 |
Analysis and application of prediction model for formation fluid sampling time while drilling
1 School of Petroleum Engineering, China University of Petroleum (East China), Qingdao 266580, Shandong, China ;
2 College of Mechanical and Electrical Engineering, Beijing University of Chemical Technology, Beijing, China ;
3 Drilling Technology Research Institute of Shengli Oilfield Service Corporation, Sinopec, Dongying, Shandong, China ;
* Correspondence should be addressed to Hongjian Ni; nihj@upc.edu.cn.
Formation sampling while drilling (FSWD) is one of the most advanced formation sampling techniques in the world. It is characterized by short operation time, shallow mud invasion, and the obtained formation data is closer to the real situation of the reservoir. During the sampling process, the first fluid that the suction probe on the borehole wall inhales is basically drilling mud filtrate. With the increase of suction time, it gradually mixes into the formation fluid, and finally the formation fluid is infinitely close to 100%. At this time, it is very important to judge the starting time of sampling. If the sampling time is too early, the percentage of samples contaminated by drilling filtrate will be higher, which can not meet the requirement of fidelity. If the sampling time is too late, the drilling fluid will stop circulating for too long, which will cause sticking. In this paper, the prediction method of sampling time is to simulate the permeability of drilling fluid to formation under certain formation parameters and drilling conditions. Based on the simulated permeability results, the suction model of sampling tool is established to simulate the pumping situation, and the variation of the content of drilling filtrate in the pumped fluid with the suction time is obtained, that is, the relationship between the contamination rate of formation fluid and the suction time, This method is of great significance to the field application of fluid sampling tools while drilling.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.