| Issue |
E3S Web Conf.
Volume 297, 2021
The 4th International Conference of Computer Science and Renewable Energies (ICCSRE'2021)
|
|
|---|---|---|
| Article Number | 01050 | |
| Number of page(s) | 5 | |
| DOI | https://doi.org/10.1051/e3sconf/202129701050 | |
| Published online | 22 September 2021 | |
Simulation of the Heat Laser of the Selective Laser Sintering Process of the Polyamide12
Laboratory of Applied Mechanics and Technologies (LAMAT), ENSET, STIS Research Center Mohammed V University, Rabat, Morocco
Laser sintering sintering is one of the most widely used 3D printing technologies, in which it transforms 3D models into authentic parts with generally excellent workmanship, the test today is to ensure the unmatched nature of the item produced, therefore hypothetically to understand and predict the thermal history in this process, the thermal models must be exact and fair, In this article, the consideration will be focused on the different models of heat flux diffusion, in the bibliography, some formulas Numbers that describe the transport of the heat source out of the powder bed have been found. A comparison between its laser source models will be established. The re-modeling takes place in MATLAB using the parameters of polyamide12.
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.