Issue |
E3S Web of Conf.
Volume 410, 2023
XXVI International Scientific Conference “Construction the Formation of Living Environment” (FORM-2023)
|
|
---|---|---|
Article Number | 02013 | |
Number of page(s) | 10 | |
Section | Reliability of Buildings and Constructions | |
DOI | https://doi.org/10.1051/e3sconf/202341002013 | |
Published online | 09 August 2023 |
Crossbars of frame buildings when changing the sign of forces
1 Moscow State University of Civil Engineering, Yaroslavskoye shosse, 26, 129337, Moscow, Russia
2 Mosinzhproekt Institute LLC, Moscow, Russia
* Corresponding author: sofyk@yandex.ru
A large number of reinforced concrete frame buildings are located in seismically dangerous regions. In case of seismic impacts plastic strains and local destructions occur in elements of such buildings, which influence sufficiently on their bearing capacity and stress-strain state when changing the sign of internal forces. This fact is not taken into account in current Russian norms on earthquake-resistant construction. The numerical research of reinforced concrete beams behavior under action of alternating load with regard to elastic-plastic properties of concrete and reinforcement has been conducted. The evaluation of influence of plastic strain maximum value in tensed reinforcement on the relative bearing capacity of the beam when changing the force sign and on the limit value of coefficient of plasticity corresponding to the destruction of compressed zone of concrete has been made. The comparison of results of numerical simulation with the results of experimental tests of beams with the same parameters has been made, which has demonstrated good convergence of numerical calculations with experimental data both in terms of bearing capacity and deformations for plasticity coefficients less than 2.5. During the experiment it has been found that when changing the sign of internal forces the through cracks form in bending reinforced concrete elements throughout the entire section height, which close afterwards if the coefficient of plasticity for reinforcement deformations does not exceed 2.5. For greater values of coefficient of plasticity the through cracks closing doesn’t take place until the destruction of the specimens due to the rupture of reinforcement bars. According to the results of the study it was concluded, that the decrease by 40% of relative bearing capacity of beams compared with reference samples as the increase of coefficient of plasticity in the first semi cycle of loading takes place. Also with the increase of the coefficient of plasticity the three times decrease of the limit values of coefficients of plasticity, corresponding to destruction of compressed concrete, when changing the sign of forces is observed. The numerical calculations of beams models for 10 and 50 alternating load cycles have been conducted with cycle asymmetry coefficient equal to -1. The conclusion has been made that under the action of alternating load with the number of loading cycles not exceeding 50 and for maximum values of coefficient of plasticity not exceeding 1.62 the insignificant decrease of relative bearing capacity of beams, not exceeding 10%, takes place.
Key words: seismic impacts / coefficient of plasticity / through cracks / stress-strain state / destruction mechanism
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.