Issue |
E3S Web of Conf.
Volume 410, 2023
XXVI International Scientific Conference “Construction the Formation of Living Environment” (FORM-2023)
|
|
---|---|---|
Article Number | 02043 | |
Number of page(s) | 7 | |
Section | Reliability of Buildings and Constructions | |
DOI | https://doi.org/10.1051/e3sconf/202341002043 | |
Published online | 09 August 2023 |
Deformation of concrete under long-term influences of different types
1 Deputy chief of the laboratory of reinforced concrete mechanics, NIIZHB named after A.A. Gvozdev, JSC Research Center of Construction
2 Moscow State University of Civil Engineering, Yaroslavskoye shosse, 26, 129337, Moscow, Russia
* Corresponding author: arleninoff@gmail.com
Introduction: Creep deformation of concrete depends at the character of stress state (compression, tension, bending, etc.). At this moment in our country as well abroad the chief parameter which determine by results of long tests concrete sample is the creep of concrete. These tests are done in the mode of uniaxial compression in spring units for one or several specimens, which simulates the compression of walls and columns. But in addition to centrally compressed elements, bending is present in an important part of structures (extracentral compressed columns, slabs, beams, etc.). In unique and difficult constructions massive reinforced concrete elements (foundations, elements of supports for equipment, columns of the lower floors of high-rise buildings, etc.) are often used. In this case the real work of structures under longterm effect of loading differs at the experimental one. Objective: Design and approbation of these methods to concrete testing samples under conditions other than standard tests - in the bending and three-axial compression modes. Materials and methods: In this scientific article describe the methodology of experimental setup for investigation of creep concrete specimens in the bending mode and in the mode imitating three-axial compression, describes the parameters of testing devices, specimens under test and principles transmission of load. Results: In this scientific article results of the experimental studies are presented in the graphical form in the article; their analysis is fulfilled. Conclusions: The perspectivity of the suggested approaches to the testing of concrete specimens for long-term loads has been shown, and recommendations for changes in GOST 24544 have been prepared.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.