Issue |
E3S Web Conf.
Volume 431, 2023
XI International Scientific and Practical Conference Innovative Technologies in Environmental Science and Education (ITSE-2023)
|
|
---|---|---|
Article Number | 06030 | |
Number of page(s) | 8 | |
Section | Industrial Innovation and Decarbonization | |
DOI | https://doi.org/10.1051/e3sconf/202343106030 | |
Published online | 13 October 2023 |
Determination of critical filament length for composites fabricated using additive technologies
Blagonravov Mechanical Engineering Research Institute of RAS, 101000 Moscow, Russia
* Corresponding author: nikalet@mail.ru
The paper shows the results of an experimental-theoretical study aimed at investigating the adhesive properties of the filament-matrix interface. The characteristic fields of strain when pulling a single filament from the matrix are shown. The filament length at which the load reaches a "plateau" is experimentally determined. According to this effect, it is possible to estimate the value of the critical filament length for a certain material, at which a local fiber break in the matrix does not affect the strength of the entire structure.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.