| Issue |
E3S Web of Conf.
Volume 525, 2024
IV International Conference on Geotechnology, Mining and Rational Use of Natural Resources (GEOTECH-2024)
|
|
|---|---|---|
| Article Number | 04008 | |
| Number of page(s) | 4 | |
| Section | Environmental Risk Assessment of Metallurgical Processes, Green Technologies and Sustainable Development | |
| DOI | https://doi.org/10.1051/e3sconf/202452504008 | |
| Published online | 20 May 2024 | |
Analysis of the influence of thermal and thermocyclic technology on the properties of maraging steel
1 Asian International University, Bukhara, Uzbekistan
2 Bukhara Engineering-Technological Institute, Bukhara, Uzbekistan
3 Tashkent State Technical University, Tashkent, Uzbekistan
* Corresponding author: jasur5004@gmai.com
The article presents experimental data obtained by studying the influence of changes in the geometry of parts made of maraging steels, depending on the modes of thermal and thermal cycling treatment with heating in the temperature range of α-γ transformation. The experiments were carried out on samples cut from hot-rolled sheets, pre-hardened at a temperature of 1000°C for 1 hour. Using the accelerated testing method, the relative change in resistance to stress corrosion damage was determined depending on the phase composition and aging temperature (strength) of maraging steel.
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.