Minimizing the flow resistance of an exhaust system by shaping the exhaust hood with a discrete adjoint method

¹ Tianjin Key Laboratory of Indoor Air Environmental Quality Control, School of Environmental Science and Engineering, Tianjin University, 92 Weijin Road, Tianjin, China
² Division of Sustainable Buildings, Department of Civil and Architectural Engineering, KTH Royal Institute of Technology, Brinellvägen 23, Stockholm, 10044, Sweden
³ School of Civil Engineering, Dalian University of Technology (DUT), 2 Linggong Road, Dalian, 116024, China

^* Corresponding author: weiliu@tju.edu.cn

Abstract

To reduce the flow resistance of an exhaust system, the method of applying individually shape-optimized exhaust hoods, namely mass-production design, is feasible. However, the combined effect of multiple exhaust hoods in an exhaust system may not be optimal in reducing the flow resistance. This investigation thus firstly validated the shape optimization of an individual exhaust hood by a discrete adjoint method to reduce the flow resistance. The design variables were the coordinates of wall boundaries of the exhaust hood. The validation used measured data from a small-scale experiment. This study then applied the validated discrete adjoint method to conduct customized design through the shape optimization of multiple exhaust hoods simultaneously in the exhaust system. The flow resistance under customized design was compared with the method of mass-production design. The results revealed that the customized design led to different shapes of individual exhaust hoods and they were different from the shape of the individually optimized exhaust hood. The flow resistance of the exhaust system under customized design and mass-production design was reduced by 57% and 36.5%, respectively. The customized design method was more effective in reducing flow resistance of the exhaust system.