Effect of nanosized titanium dioxide and zinc oxide as antimicrobial agents on early compressive strength of high-performance concrete

Open Access

Issue		E3S Web of Conf. Volume 488, 2024 1^st International Conference on Advanced Materials & Sustainable Energy Technologies (AMSET2023)


Article Number		03003
Number of page(s)		11
Section		Green Buildings; Carbon Capture & Recycling of Energy Materials
DOI		https://doi.org/10.1051/e3sconf/202448803003
Published online		06 February 2024

L. Ding, W. J. Weiss, E. R. Blatchley, Effects of Concrete Composition on Resistance to Microbially Induced Corrosion. Journal of Environmental Engineering, 143, 6 (2017) [Google Scholar]
M. Harilal, B. Anandkumar, B. B. Lahiri, R. P. George, J. Philip, S. K. Albert, Enhanced biodeterioration and biofouling resistance of nanoparticles and inhibitor admixed fly ash based concrete in marine environments. Int. Bio. and Biode., 155, (2020) [Google Scholar]
E. O. Ogunsona, R., Muthuraj, E. Ojogbo, O. Valerio, T. H. Mekonnen, Engineered nanomaterials for antimicrobial applications: A review. In App. Mat. Tod., (2020). [Google Scholar]
P. Hughes, D. Fairhurst, I. Sherrington, N. Renevier, L. H. G. Morton, P. C. Robery, L. Cunningham, Microbial degradation of synthetic fibre-reinforced marine concrete. Int. Bio. and Bio., 86. (2014) [Google Scholar]
J. Ly, J. Mao, H. Ba, Influence of marine microorganisms on the permeability and microstructure of mortar. Con. and Bui. Mat., (2015) [Google Scholar]
D. Allsopp, K. J. Seal, C. C. Gaylarde, Introduction to biodeterioration. In Introduction to Biodeterioration (2010) [Google Scholar]
X. Pan, Z. Shi, C. Shi, T. C. Ling, N. A. Li,Review on surface treatment for concrete – Part 2: Performance. Con. and Bui. Mat., (2017) [Google Scholar]
K. Pietrzak, A. Otlewska, D. Danielewicz, Dybka, K., Pangallo, D., Kraková, L., Puškárová, A., Bučková, M., Scholtz, V., Ďurovič, M., Surma-Ślusarska, B., Demnerová, K., and Gutarowska, B. Disinfection of archival documents using thyme essential oil, silver nanoparticles misting and low temperature plasma. Jou. of Cul. Her. (2017). [Google Scholar]
L. Qiu, S. Dong, A. Ashour, B. Han, Antimicrobial concrete for smart and durable infrastructures: A review. Con. and Bui. Mat. (2020). [Google Scholar]
T. V. Reshma, M. Manjunatha, A. Bharath, R. B. Tangadagi, J. Vengala, L. R. Manjunatha, Influence of ZnO and TiO₂ on mechanical and durability properties of concrete prepared with and without polypropylene fibers. Mat., 18, (2021). [Google Scholar]
E. Schifano, D. Cavallini, G. De Bellis, M. P. Bracciale, A. C. Felici, M. L. Santarelli, M. S. Sarto, D. Uccelletti, Antibacterial effect of zinc oxide-based nanomaterials on environmental biodeteriogens affecting historical buildings. Nanomaterials (2020). [Google Scholar]
N. Wattanawong, D. Aht-Ong, Antibacterial activity, thermal behaviour, mechanical properties and biodegradability of silver zeolite/poly(butylene succinate) composite films. Poly. Deg. and Sta. (2021) [Google Scholar]
J. A. Abdalla, B. S. Thomas, R. A. Hawileh, J. Yang, B. B. Jindal, E. Ariyachandra Influence of nano-TiO₂, nano-Fe₂O₃, nanoclay and nano-CaCO3 on the properties of cement/geopolymer concrete. Cle. Mat., (2022) [Google Scholar]
Dyshlyuk, L., Babich, O., Ivanova, S., Vasilchenco, N., Atuchin, V., Korolkov, I., Russakov, D., and Prosekov, A. Antimicrobial potential of ZnO, TiO2 and SiO2 nanoparticles in protecting building materials from biodegradation. Int. Bio. and Bio., (2020) [Google Scholar]
R. Goyal, V. K. Verma, N. B. Singh, Effect of nano TiO2 and ZnO on the hydration properties of Portland cement. Mat. Tod.: Proceedings (2022). [Google Scholar]
Malaysian Standards. Portland Cement - Part 1: Composition, Specifications, and Conformity Criteria for Common Cements (MS EN 197-1:2014) (2014). [Google Scholar]
European Committee for Standardization, Aggregates for Concrete (EN 12620:2002). Brussels, Belgium: CEN, (2002) [Google Scholar]
ASTM International, Standard Specification for Coal Fly Ash and Raw or Calcined Natural Pozzolan for Use in Concrete (Standard No. ASTM C618-22), (2022). [Google Scholar]
European Committee for Standardization, Admixtures for concrete, mortar and grout - Part 2: Concrete admixtures - Definitions, requirements, conformity, marking and labelling (EN 934-2 (2012). [Google Scholar]
F. Amor, M. Baudys, Z. Racova, L. Scheinherrová, L. Ingrisova, P. Hajek, Contribution of TiO₂ and ZnO nanoparticles to the hydration of Portland cement and photocatalytic properties of high-performance concrete. Case Studies in Con. Mat., 16, (2022). [Google Scholar]
L. Wu, M. Mei, Z. Li, S. Liu, X. Wang, Study on photocatalytic and mechanical properties of TiO2 modified pervious concrete. Case Studies in Con. Mat., 17, (2022). [Google Scholar]
K. A. Olonade, A. U. Adebanjo, S. N. Abd Razak, V. Kumar, Chemistry as a knowledge base for the development of sustainable cementitious materials. African Jour. of Chem. Edu, (2023) [Google Scholar]
S. S. Pathak, G. R. Vesmawala Effect of nano TiO₂ on mechanical properties and microstructure of concrete. Mat. Tod.: Proceedings, (2022). [Google Scholar]
H. J. Choi, J. J. Park, D. Y. Yoo, Benefits of TiO2 photocatalyst on mechanical properties and nitrogen oxide removal of ultra-high-performance concrete. Con. and Build. Mat., (2021) [Google Scholar]
F. Hu, Y. Wu, C. Sun, C. Xu, B. Zhu, Q. Wang, Q. Shi, S. Li, D. Zhang, Influence of charge compensation on the photoluminescence and temperature sensing of zinc titanate composites. Ceram. Intl. (2023). [Google Scholar]
S. Perween, M. Beg, R. Shankar, S. Sharma, A. Ranjan, Effect of zinc titanate nanoparticles on rheological and filtration properties of water based drilling fluids. Jour. of Petro. Sci. and Eng., (2018) [Google Scholar]
A.U. Adebanjo, N. Shafiq, S.N.A. Razak, V. Kumar, S.A. Farhan, P. Singh, A. S. Abubakar, Design and modeling the compressive strength of high-performance concrete with silica fume: a soft computing approach, Soft Comp. (2023). [Google Scholar]
V. Kumar, S. R. M. Kutty, S. N. Abd Razak, N. Shafiq, A. Adebanjo, L. Baloo, A. A. Azougagh, and R. Iseni, Exploring the untapped potentials of oily sludge ash blended with fly ash for geopolymer binder via waste valorisation approach. Jour. of Hazard. Mat. Letrs., (2023) [Google Scholar]
O. J. Udeze, B. S. Mohammed, A. U. Adebanjo, I. Abdulkadir, Optimizing an eco-friendly high-density concrete for offshore applications: A study on fly ash partial replacement and graphene oxide nano reinforcement. Case Studies in Chem. and Env. Eng., 100592, (2023) [Google Scholar]
A. Usman, M. Hartadi Sutanto, M. Bin. Napiah, N. Shehu Aliyu Yaro, Response Surface Methodology Optimization in Asphalt Mixtures: A Review. In Response Surface Methodology in Engineering Science. (2021) [Google Scholar]

Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.

Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.

Initial download of the metrics may take a while.