Bed-load measurements on large, sand-bed rivers in the United States

US Army Corps of Engineers, Coastal and Hydraulics Laboratory, Vicksburg MS, USA

^* David Abraham: david.d.abraham@erdc.dren.mil

Abstract

The movement of bed forms (sand dunes) in large sand-bed rivers is being used to determine the transport rate of bed load. The ISSDOTv2 (Integrated Section Surface Difference Over Time version 2) methodology uses time sequenced differences of measured bathymetric surfaces to compute the bed-load transport rate. The method was verified using flume studies [1]. In general, the method provides very consistent and repeatable results, and also shows very good fidelity with most other measurement techniques. Over the last 7 years we have measured, computed and compiled what we believe to be the most extensive data set anywhere of bed-load measurements on large, sand bed rivers. Most of the measurements have been taken on the Mississippi, Missouri, Ohio and Snake Rivers in the United States. For cases where multiple measurements were made at varying flow rates, bed-load rating curves have been produced. This paper will provide references for the methodology, but is intended more to discuss the measurements, the resulting data sets, and current and potential uses for the bed-load data.