Issue |
E3S Web Conf.
Volume 118, 2019
2019 4th International Conference on Advances in Energy and Environment Research (ICAEER 2019)
|
|
---|---|---|
Article Number | 01051 | |
Number of page(s) | 5 | |
Section | Energy Engineering, Materials and Technology | |
DOI | https://doi.org/10.1051/e3sconf/201911801051 | |
Published online | 04 October 2019 |
The Grindability of Biochars from Agroforestry Biomass Prepared under Different Torrefied Conditions
School of Energy and Mechanical Engineering, Nanjing Normal University, Nanjing 210023, China
* Corresponding author: luping@njnu.edu.cn
The torrefaction experiments of four biomass including agricultural biomass (corn straw (CS) and wheat straw (WS)) and forestry biomass (polar wood (PW) and cedar wood (CW)) were carried out in a fixed bed reactor at torrefaction temperature of 200-300°C and holding time of 10-60min, the effects of torrefaction temperature and holding time on biochar grindability based on the component analysis and the particle size distribution of ground biomass and biochars. The obtained results indicated that the mass fraction of ground biochar with particle size less than 150 μm increases with increasing torrefaction temperature, and the mass fraction of ground biochar with particle size less than 150 μm achieves 100%. The larger the λC, the better the grindability of biochar. The correlation between the grindability of the woody biochar and the λC is not as good as that of the straw biochar. The grindability of corn straw biochar and cedar wood biochar is improved with the increase of holding time at the same torrefaction temperature, however, the grindability of wheat straw biochar and polar wood biochar gets a little change, which can keep good grindability at higher torrefaction temperature large than 275°C.
© The Authors, published by EDP Sciences, 2019
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.