Issue |
E3S Web Conf.
Volume 193, 2020
International Conference on Modern Trends in Manufacturing Technologies and Equipment (ICMTMTE 2020)
|
|
---|---|---|
Article Number | 01038 | |
Number of page(s) | 7 | |
Section | Agricultural Science | |
DOI | https://doi.org/10.1051/e3sconf/202019301038 | |
Published online | 08 October 2020 |
Static analysis and strength calculation of drive shaft of large-scale cone crusher
National University of Science and Technology «MISIS», Moscow, Russian Federation
* Corresponding author: lvsedykh@mail.ru
The paper analyzes the causes of failures of coarse crushers “KKD 1500-180” at JSC “Almalyk MMC”. It has been established that the most common cause of these failures is a drive shaft failure. Static analysis of the strength of the drive shaft was performed using Autodesk Inventor 2020 CAD software. A dangerous shaft section was found, and recommendations aimed at improving its operability were proposed.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.