Issue |
E3S Web Conf.
Volume 236, 2021
3rd International Conference on Energy Resources and Sustainable Development (ICERSD 2020)
|
|
---|---|---|
Article Number | 04028 | |
Number of page(s) | 4 | |
Section | Green Technology Innovation and Intelligent Application of Environmental Equipment | |
DOI | https://doi.org/10.1051/e3sconf/202123604028 | |
Published online | 09 February 2021 |
Parameters adaptive backstepping control of PMSM using DTC method
Planning Review Center, Economic and Electrical Research Institute of Shanxi Electrical Power Company of SGCC, Taiyuan, Shanxi, 030002, China
* Corresponding author’s e-mail: ysuzhxm@126.com
The torque and flux ripple of traditional DTC control of PMSM is large, and due to the lack of adaptive control system, the change of the system parameters has a great impact on the steady and transient control performance of the motor speed. Based on the traditional DTC control algorithm, a parameter identification adaptive backstepping DTC control algorithm is proposed in this paper. Because the backstepping controller is used to replace PI controller and flux hysteresis controller, the steady-state and transient performance of the system is obviously improved. At the same time, a parameter identification adaptive controller is designed, which can effectively suppress the influence of parameter changes on the speed control performance. The simulation results verify the correctness and effectiveness of the control algorithm. The control algorithm can significantly improve the steady-state and transient performance of the system under the condition of parameter mutation.
© The Authors, published by EDP Sciences 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.