Jet ignition in small two-stroke engines: an experimental survey on benefits and challenges

Università degli Studi di Firenze, Department of Industrial Engineering, Via di Santa Marta 3, 50134 Firenze, Italy

^* Corresponding author: giovanni.ferrara@unifi.it

Abstract

Increasingly stringent policy on carbon dioxide have proved to be a severe constraint on the design of light two-stroke (2S) engines. The enhancement of efficiency is claimed to be the main target to make these devices compliant with future regulations. Low-Pressure Direct Injection (LPDI) was found to be effective in the reduction of fuel short circuit, thus improving efficiency and mitigating pollution. Innovative combustion technologies are required to exploit further the fuel potential. Jet Ignition (JI), i.e., ignition provided by means of hot turbulent jets, was found to improve the fuel ignition process, leading to a faster and more uniform combustion. Several benefits are shown in over forty years of Literature, from the higher performance to wider flammability limits. However, few studies have been performed on small 2S engines, for which only full-load data are available. This paper aims at experimentally evaluating benefits and challenges of adopting the JI technology on light 2S LPDI engines at both full- and low- load operation. Different configurations of passive prechambers have been investigated in terms of indicated cycle, brake efficiency and cycle-to-cycle variation. A sensitivity analysis on the spark timing was performed to fine-tune the combustion process. Results show the adequacy of the JI for use in devices operating close to full torque, like garden tools; however, issues related to the excessive amount of residual gas or to the rapid pressure decrease during the expansion phase were highlighted. Different solutions for solving these challenges are proposed.