| Issue |
E3S Web Conf.
Volume 376, 2023
International Scientific and Practical Conference “Environmental Risks and Safety in Mechanical Engineering” (ERSME-2023)
|
|
|---|---|---|
| Article Number | 01018 | |
| Number of page(s) | 5 | |
| Section | I Environmental Risks and Safety in Mechanical Engineering | |
| DOI | https://doi.org/10.1051/e3sconf/202337601018 | |
| Published online | 31 March 2023 | |
The influence of 3D-printing technological conditions on the performance properties of master models
Moscow Automobile and Road Construction State Technical University (MADI), 64 Leningradsky Ave., 125319 Moscow, Russia
* Corresponding author: nbaurova@mail.ru
The influence of 3D-printing technological conditions on the performance properties of master models has been investigated. It is shown that strength properties of master models depend significantly on two parameters: layer thickness and percentage of filling. Recommendations onthe choice of 3D-printing conditions for manufacturing master models, as well as products based on master models, are presented.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.