Issue |
E3S Web Conf.
Volume 376, 2023
International Scientific and Practical Conference “Environmental Risks and Safety in Mechanical Engineering” (ERSME-2023)
|
|
---|---|---|
Article Number | 03006 | |
Number of page(s) | 8 | |
Section | III Civil and Environmental Engineering | |
DOI | https://doi.org/10.1051/e3sconf/202337603006 | |
Published online | 31 March 2023 |
Influence of reinforcement parameters on the properties of fibropenotoof concrete
1 North-caucasian state academy, 36b, Stavropolskaya str., 369000 Cherkessk, Russia
2 Nevinnomyssk State Humanitory and Technical Institute, 17, Bulvar Mira str., 357108 Nevinnomyssk, Russia
* Corresponding author: pochta@mail.ru
The influence of the parameters of dispersed reinforcement on the properties of fibro-foam concrete analyzed. The experiment planning matrix was built. A series of samples of various compositions made of fibro-foam concrete were tested for compression and bending. The regression equations obtained in coded form, which are adequate to the calculated ones, based on the Fisher criterion. The analysis of the equations carried out and the response surfaces constructed from them, which showed that the highest values of the optimization parameters correspond to the design area with high µv and low l/d. It has been established that the introduction of a sufficient amount of short fibers into the foam concrete matrix leads to the strengthening of the material, which is provided not only by the reinforcing properties of the fibers, but also by their ability to positively influence the structure of aerated concrete.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.