| Issue |
E3S Web of Conf.
Volume 390, 2023
VIII International Conference on Advanced Agritechnologies, Environmental Engineering and Sustainable Development (AGRITECH-VIII 2023)
|
|
|---|---|---|
| Article Number | 03030 | |
| Number of page(s) | 5 | |
| Section | Information Technologies, Automation Engineering and Digitization of Agriculture | |
| DOI | https://doi.org/10.1051/e3sconf/202339003030 | |
| Published online | 01 June 2023 | |
Theoretical determination of the speed and number of revolutions of the grain grinder hammer propeller
1 Termez State University, 43, Street Barkamol avlod, Termez, 190111, Uzbekistan
2 Termez Engineering and Technological Institute, Termez, Uzbekistan
* Corresponding author: fkarshiev@mail.ru
A mini grain grinder device was created for small farms, which is used to prepare feed by grinding grains. The main working organ of the grain grinder is a propeller with a hammer, and the grinding of grains during the work process depends on the rotation speed of the hammer and the number of revolutions of the propeller. Because when the propeller rotates, the speed of the hammer attached to it must be sufficient to crush the grains. With this in mind, theoretical studies were conducted and the rotation speed and number of rotations of the hammer propeller of the grinding device needed to grind the grains were determined. According to the research, the speed of the propeller hammer should be at least 40.2 m/s for grain crushing in the device, and this speed is ensured when the number of rotations of the hammer propeller reaches 1785 rev/min when the radius of the hammer propeller is r = 0.215 m. For rapid grinding of nutritious grains in the grinding machine, the speed of the hammer should be higher than 40.2 m/s and the number of propeller revolutions should be higher than 1785 rev/min.
© The Authors, published by EDP Sciences, 2023
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.