Open Access
Issue |
E3S Web Conf.
Volume 67, 2018
The 3rd International Tropical Renewable Energy Conference “Sustainable Development of Tropical Renewable Energy” (i-TREC 2018)
|
|
---|---|---|
Article Number | 04028 | |
Number of page(s) | 6 | |
Section | Eco Tropical Built Environment | |
DOI | https://doi.org/10.1051/e3sconf/20186704028 | |
Published online | 26 November 2018 |
- Stiling, James, Simon Li, Pieter Stroeve, Jim Thompson, Bertha Mjawa, Kurt Kornbluth, and Diane M. Barrett. “Performance evaluation of an enhanced fruit solar dryer using concentrating panels.” Energy for sustainable development 16, no. 2 (2012): 224–230. [CrossRef] [Google Scholar]
- Gutti, Babagana, Silas Kiman, and Ahmed M. Murtala. “SOLAR DRYER-AN EFFECTIVE TOOL FOR AGRICULTURAL PRODUCTS PRESERVATION.” Journal of Applied Technology in Environmental Sanitation 2, no. 1 (2012). [Google Scholar]
- Hussain, Muhammad Ibrar, Esmail MA Mokheimer, and Shakeel Ahmed. “Optimal Design of a Solar Collector for Required Flux Distribution on a Tubular Receiver.” Journal of Energy Resources Technology 139, no. 1 (2017): 012006. [CrossRef] [Google Scholar]
- Alleyne, Fatima S., and Rebecca R. Milezarek. “Design of solar thermal dryers for 24 hour food drying.” United State Department of Agriculture, Heating Processed Food Research Unit (2015). [Google Scholar]
- Prakash, T. B., and S. Satyanayarana. “Performance analysis of solar drying system for Guntur Chili.” Int J Latest Trends Eng Technol 4 (2014):283–298. [Google Scholar]
- Syuhada A. and Maulana M.I. Characteristics of Heat Transfer On Solar Collector Channel By Using A Sharp Turn, The International Conference on Thermal Science and Technology (ICTST) 2017, November 17-19th, (2017). [Google Scholar]
- Ji, Xu, Ming Li, Yunfeng Wang, Deli Ling, and Xi Luo. “Performance characteristics of solar drying system for agricultural products.” BULGARIAN CHEMICAL COMMUNICATIONS 48 (2016):120–125. [Google Scholar]
- Tiwari, Anupam. “A review on solar drying of agricultural produce.” journal of food (2016). [Google Scholar]
- Teja, Ravi, F. Z. Pathan, and Mandar Vahadne. “Optimization of Heat Transfer through Rectangular Duct.” International Research Journal of Engineering and Technology (IRJET) 2, no. 4 (2015): 1906–1910. [Google Scholar]
- M. Yaghoubi, F. Ahmadi, and M. Bandehee, 2013, Analysis of Heat Losses of Absorber Tubes of Parabolicthrough Collector of Shiraz (Iran) Solar Power Plant, Journal of Clean Energy Technologies, Vol. 1, No. 1, January 2013 [Google Scholar]
- Muneesh Sethi, Varun, N.S. Thakur, 2012, Correlations for solar air heater duct with dimpled shape roughness elements on absorber plate, Solar Energy 86 (2012) 2852–2861. [CrossRef] [Google Scholar]
- Sakhrieh, A. Al-Ghandoor, 2013, Experimental investigation of the performance of five types of solar collectors, Energy Conversion and Management 65 (2013) 715–720 [CrossRef] [Google Scholar]
- A.P. Omojaro, L.B.Y. Aldabbagh, 2010, Experimental performance of single and double pass solar air heater with fins and steel wire mesh as absorber, Applied Energy 87 (2010) 3759–3765. [CrossRef] [Google Scholar]
- M.A. Oyinlola, G.S.F. Shire, R.W. Moss. 2015, Investigating the effects of geometry in solar thermal absorber plates with micro-channels, International Journal of Heat and Mass Transfer 90 (2015) 552–560 [CrossRef] [Google Scholar]
- Rajendra Karwa & Girish Chitoshiya, 2013, Performance study of solar air heater having vdown discrete ribs on absorber plate, Energy 55 (2013) 939–955. [CrossRef] [Google Scholar]
- Dara, J. E., K. O. Ikebudu, N. O. Ubani, C. E. Chinwuko, and O. A. Ubachukwu. “Evaluation of a passive flat-plate solar collector.” Int. J. of Advancements in Res. & Tech 2, no. 1 (2013). [Google Scholar]
- Syuhada, A., M. Hirota, H. Fujita, S. Araki, M. Yanagida, and T. Tanaka. “Heat (mass) transfer in serpentine flow passage with rectangular crosssection.” Energy conversion and management 42, no. 15-17 (2001): 1867–1885. [CrossRef] [Google Scholar]
- Hirota, M., H. Fujita, A. Syuhada, S. Araki, T. Yoshida, and T. Tanaka. “Heat/mass transfer characteristics in two-pass smooth channels with a sharp 180-deg turn.” International Journal of Heat and Mass Transfer 42, no. 20 (1999): 3757–3770. [CrossRef] [Google Scholar]
- Syuhada, A., M. Hirota, H. Fujita, S. Araki, M. Yanagida, and T. Tanaka. “Heat (mass) transfer in serpentine flow passage with rectangular crosssection.” Energy conversion and management 42, no. 15-17 (2001): 1867–1885. [CrossRef] [Google Scholar]
- Hirota, Masafumi, Hideomi Fujita, Hiroshi Nakayama, and Ahmad Syuhada. “Heat(mass) transfer characteristics in serpentine flow passages with a sharp turn.” Nagoya University, School of Engineering, Memoirs 52, no. 1 (2000): 1–52. [Google Scholar]
- Rosario, Ariane. “Calculating the Solar Energy of a Flat Plate Collector.” Undergraduate Journal of Mathematical Modeling: One+ Two 6, no. 1 (2014): 1. [Google Scholar]
- Chabane, Foued, Noureddine Moummi, and Said Benramache. “Experimental study of heat transfer and thermal performance with longitudinal fins of solar air heater.” Journal of advanced research 5, no. 2 (2014): 183–192. [CrossRef] [PubMed] [Google Scholar]
- Mozumder, Atish, Anjani K. Singh, and Pragati Sharma. “Study of cylindrical honeycomb solar collector.” Journal of Solar Energy 2014 (2014). [Google Scholar]
- Mohammad karim, Ahmadreza, Alibakhsh Kasaeian, and Abdolrazagh Kaabinejadian. “Performance investigation of solar evacuated tube collector using TRNSYS in Tehran.” International Journal of Renewable Energy Research (IJRER) 4, no. 2 (2014): 497–503. [Google Scholar]
- Mishra, Dilip. “Experimental Analysis of Thermal Performance of Evacuated U-Tube Solar Collector.” Advance Physics Letters 2, no. 3 (2015). [Google Scholar]
- Ihaddadene, Nabila, Razika Ihaddadene, and Abdelwahaab Betka. “Experimental investigation of Using a Novel insulation Material on the Functioning of a Solar Thermal Collector.” Journal of Solar Energy Engineering 140, no. 6 (2018):061001 [CrossRef] [Google Scholar]
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.