| Issue |
E3S Web Conf.
Volume 8, 2016
Mineral Engineering Conference MEC2016
|
|
|---|---|---|
| Article Number | 01066 | |
| Number of page(s) | 9 | |
| DOI | https://doi.org/10.1051/e3sconf/20160801066 | |
| Published online | 16 September 2016 | |
Design of an electromagnetic mill. Its technological and control system structures for dry milling
1 AGH University of Science and Technology, Faculty of Mining and Geoengineering, Department of Environmental Engineering and Mineral Processing, Poland
2 Silesian University of Technology, Faculty of Automatic Control, Electronics and Computer Science, Institute of Automatic Control, Poland
a Corresponding author: wolosiewiczm@gmail.com
A modern industry could not operate without complex processing of mineral raw materials, supported by innovative technologies. That is the reason to design and create a new electromagnetic mill. The paper presents a design of its technological structure and control system. It is presented that, in relation to traditional solutions, the electromagnetic mill is a fully automated system, which affects the effectiveness of its operation. The effectiveness and efficiency of processes depend on a proper selection of the physical parameters of the system and process parameters. The device is characterized by low energy consumption.
© Owned by the authors, published by EDP Sciences, 2016
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.