| Issue |
E3S Web Conf.
Volume 184, 2020
2nd International Conference on Design and Manufacturing Aspects for Sustainable Energy (ICMED 2020)
|
|
|---|---|---|
| Article Number | 01013 | |
| Number of page(s) | 5 | |
| DOI | https://doi.org/10.1051/e3sconf/202018401013 | |
| Published online | 19 August 2020 | |
Taguchi Optimisation In Machining EN18 Using Coated Tool Under Dry and MQL Condition
1 Assoc.Professor, GRIET, Mechanical Engineering Department, Bachupally 500090, Hyderabad, India.
2 UG Student, GRIET, Mechanical Engineering Department, Bachupally 500090, Hyderabad, India.
3 PG Student, GRIET, Mechanical Engineering Department, Bachupally 500090, Hyderabad, India.
Turning is one of the initial basic machining operation that prevails in assembly and production process. Modern techniques have been practices in rapid and eco-friendly production systems. Present study deals with the investigation of turning process on EN 18 steel which is been shown its existence in automobiles industries. Turning operation was performed using a coated tool insert with varying cutting speed (100, 125 and 150 mm/min), feed rate (0.05, 0.5, 0.15 mm/rev) and depth of cut (0.4, 0.8, 1.2 mm) at both dry and MQL conditions. The results obtained was compared to optimize the effect of minimum quality lubrication on surface roughness. Experimentally it was observed that speed of 100 m/min with combination of feed of 0.05 mm/rev and 0.4 mm depth of cut was found to be optimized for surface roughness in both the cases. The mathematical model generated for surface roughness and MRR for both dry and MQL turning models having better regression fit as it closer to 100. From ANOVA analysis feed was proved to be the highest contributing factor for surface roughness and for MRR speed is the most significant factor for both dry and MQL turning
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.