| Issue |
E3S Web Conf.
Volume 184, 2020
2nd International Conference on Design and Manufacturing Aspects for Sustainable Energy (ICMED 2020)
|
|
|---|---|---|
| Article Number | 01060 | |
| Number of page(s) | 4 | |
| DOI | https://doi.org/10.1051/e3sconf/202018401060 | |
| Published online | 19 August 2020 | |
Experimental investigation in machining EN18 using coated tool under dry and MQL condition
1 Assoc.Professor, GRIET, Mechanical Engineering Department, Bachupally 500090, Hyderabad, India.
2 PG Student, GRIET, Mechanical Engineering Department, Bachupally 500090, Hyderabad, India.
* Corresponding author: author@e-mail.org
EN 18 is one of the versatile metal that exists its presences in all the industrial, transportation and building equipment’s. Machining of these material is done on large scale and consumes a whole lot of lubrication unit. Present paper discuss regarding the usage and substitutional to flood coolant systems by minimum quality lubrication ((MQL) systems for economical friendly green machining operation. Using three-factor parameters speed (50, 75, 100 m/min), feed (0.05, 0.1, 0.15 mm/rev) and depth of cut (0.4, 0.8, 1.2 mm) are varied and turned on the EN 18 steel. The experimental outcomes of surface roughness is discussed with comparison with dry machining and ST-CUT 54 MQL machining. It was observed that with MQL turning the roughness produce better compared to dry machining. The optimum condition was found to be cutting speed at 100m/min, feed at 0.05mm/rev and depth of cut at 0.4mm. The outcomes are useful for improved machining industrial practices.
© The Authors, published by EDP Sciences, 2020
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.