| Issue |
E3S Web Conf.
Volume 328, 2021
International Conference on Science and Technology (ICST 2021)
|
|
|---|---|---|
| Article Number | 07003 | |
| Number of page(s) | 5 | |
| Section | Mechanical, Computational & Simulation, Heat Treatment, Bio Composite | |
| DOI | https://doi.org/10.1051/e3sconf/202132807003 | |
| Published online | 06 December 2021 | |
Meat Cutting Machine Shaft Design and Analysis
Department of Mechanical Engineering, Faculty of Engineering, Universitas Musamus, Merauke 99600, Indonesia
* Corresponding author :cipto@unmus.ac.id
This study analyzes the maximum load on the shaft construction with a diameter of 12 mm and a length of 581 mm. The shaft is designed as a shaft for cutting meat with a capacity of 5 kg. The analysis was performed using the finite element analysis method included in the Autodesk software. According to mathematical calculations, the shaft is considered safe because the value of the admissible tension τa = 7.380 kg / mm2 is greater than the maximum tension τp 5.62 kg / mm2. Based on the simulation results of the test, the shaft experiences a maximum off-stress of 61.89 MPa, a maximum displacement of 0.07715 mm, , and a safety factor of 3.34 µl so that the shaft is classified as safe for use with a Load capacity of 5 Kg
Key words: Rice transport vehicle / Strength analyzed / Finite element analysis
© The Authors, published by EDP Sciences, 2021
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.