| Issue |
E3S Web of Conf.
Volume 525, 2024
IV International Conference on Geotechnology, Mining and Rational Use of Natural Resources (GEOTECH-2024)
|
|
|---|---|---|
| Article Number | 06007 | |
| Number of page(s) | 7 | |
| Section | Infrastructure Problems of Mining Engineering, Transport, Electromechanics and Energy | |
| DOI | https://doi.org/10.1051/e3sconf/202452506007 | |
| Published online | 20 May 2024 | |
Friction in roller technological machines
1 Tashkent University of Architecture and Civil Engineering, Tashkent, Uzbekistan
2 Karshi Engineering economics Institute, Karshi, Uzbekistan
* Corresponding author: shavkat-xurramov59@mail.ru
The study is devoted to solving the problem of determining the patterns of friction stress distribution in the symmetric roll module contact zone. A mathematical model was developed that describes the patterns of friction stress distribution in the contact zone of roll modules. It was established that the ratio of friction stress to normal stress in the contact zone of roll modules is not constant and changes at each point of the contact zone. It was revealed that the ratio of friction stress to normal stress depends on external forces acting on the roll supports, geometric and kinematic parameters of the roll module, and deformation properties of the strip and roller coating.
© The Authors, published by EDP Sciences, 2024
This is an Open Access article distributed under the terms of the Creative Commons Attribution License 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
Current usage metrics show cumulative count of Article Views (full-text article views including HTML views, PDF and ePub downloads, according to the available data) and Abstracts Views on Vision4Press platform.
Data correspond to usage on the plateform after 2015. The current usage metrics is available 48-96 hours after online publication and is updated daily on week days.
Initial download of the metrics may take a while.